Provision ISR N series Specifications download pdf (Page 4)

5 6

Tailplate

Mount screw

Lens

Back focus screw

Lens mount ring

Auto-Iris Socket

RS-485 Interface

12V Power In

Video Out

Power Indicator

Led

Structure and Components

Tailplate Sketch

- Connecting the lens

Before mounting a lens, please check whether it is a C-mount or

CS - mount lens. The back focus is set for the CS-mount lens at the

factory. Connect your lens by turning it clockwise to the Lens mount

ring (4), In case of auto iris lens, connect the lens cable to the Auto

iris socket (6).

- Video out

Connect the video out (8) of the camera to the monitor or other video

equipments (DVR) with a 75 ohm cable (RG59).

- Connecting the power

Before connecting your power supply, please make sure it’s the

correct one (12VDC). Power is connect by two wires.

Make sure you plug the power in the right direction "+12V" = "+”,

“GND" = "-"(10).

- Connection RS845

If you want to connect an external control device or a DVR stand

alone. You can connect the two wires to the RS485 on the Terminal

Block (9). Make sure to connect +/- in the right sockets (“+” is the ﬁrst

one from the left and “-“ in the one after).

- Focusing

Back focus – back focus is adjusted when the camera leaves the

factory, Therefore no more adjustments is needed.

However, in case you can’t reach optimize focus by the lens focus

ring(4), untie the back focus screw(2), then turn the lens mount ring

clockwise or counter clockwise until the image is clear, then retighten

the lens mount screw.

Connecting your camera

1 2 3 4 5 6 7 8 9 ... 22 23

No comments

Provision ISR N series Specifications Page 4